TOONLOK ST 2-Pack with End Caps — Free Shipping

FREE SHIPPING — Free standard U.S. shipping on this bundle.

Build a full 12-inch pontoon accessory track with two connecting TOONLOK ST Platforms.

This package includes two 6-inch ST Standard-Fit Platform sections, complete mounting hardware and one matching-color pack of TOONLOK end caps. Connect both sections to create one continuous 12-inch standard 3-inch accessory track, or install them separately in two locations.

This bundle saves $4.99 compared with purchasing two individual platform sections and also includes the end-cap pack and free standard U.S. shipping.

Please Confirm the Fit Before Ordering

The ST Platform fits most pontoons with approximately 1.25-inch square upper fence tubing.

Choose the ST Platform if:

• Your upper fence tubing is approximately 1.25 inches wide
• The exterior fence sheeting ends below the top of the upper tubing
• Enough of the square upper rail is exposed for the platform to fit securely
• Your pontoon uses a typical square-tube fence design

The ST Platform will not fit correctly if the complete upper fence assembly is wider than 1.25 inches or if exterior sheeting extends completely to the top and increases the width of the rail.

Do not select the platform based only on the boat manufacturer. Measure the actual upper fence assembly before ordering. If unsure, contact support@listmarinesolutions.com with the pontoon’s year, make and model, the rail measurement and a clear picture of the upper fence rail.

What’s Included

• 2 six-inch ST TOONLOK Platform sections
• 4 stainless-steel mounting bolts
• 4 washers
• 4 nylon-insert lock nuts
• 8 self-tapping screws for additional support
• 1 matching-color pack of TOONLOK end caps
• Free standard U.S. shipping

Features

• Creates a standard 3-inch accessory track on pontoon fencing
• Two sections connect to create one continuous 12-inch track
• Sections may also be installed separately
• Compatible accessories can be mounted and repositioned
• Manufactured from outdoor-grade ASA material
• Strength tested
• Stainless-steel mounting hardware included
• Designed and manufactured in Michigan, USA
• Patent pending
• Available in black, white or gray

Installation

Test-fit both sections before installing or tightening any hardware. Confirm that each platform fits completely around the fence assembly, sits level and is not being forced, spread apart or distorted.

Align the male and female interlocking ends to connect the two sections. The side connectors align the sections but do not replace the required mounting hardware. Secure each section independently using its included hardware.

Some pontoon models require drilling with a 1/4-inch drill bit, which is not included. Inspect both sides of the fence for wiring, cables and other obstructions before drilling. Do not overtighten the mounting hardware.

Important

This package includes two ST Platform sections, their listed mounting hardware and one pack of end caps. Rod holders and other track-mounted accessories are sold separately.

TOONLOK platforms are not intended to be used as steps, seats, grab handles, tie-down points or lifting devices.

TOONLOK — Built to Expand.