TOONLOK AT 2-Pack with End Caps — Free Shipping

FREE SHIPPING — Free standard U.S. shipping on this bundle.

Build a full 12-inch pontoon accessory track with two connecting TOONLOK AT Platforms.

This package includes two 6-inch AT Extended-Fit Platform sections, complete mounting hardware, six shims and one matching-color pack of TOONLOK end caps. Connect both sections to create one continuous 12-inch standard 3-inch accessory track, or install them separately in two locations.

This bundle saves $4.99 compared with purchasing two individual platform sections and also includes the end-cap pack and free standard U.S. shipping.

Please Confirm the Fit Before Ordering

The AT Platform is designed for pontoons with wider upper fence construction or exterior fence sheeting that extends completely to the top of the upper fence rail.

Choose the AT Platform if:

• The exterior fence sheeting extends completely to the top rail
• The complete upper fence assembly measures more than 1.25 inches wide
• The combined width of the tubing and sheeting is no more than approximately 1.5 inches
• A standard 1.25-inch platform would not fit completely around the fence assembly

Do not select the platform based only on the boat manufacturer. Measure the actual upper fence assembly before ordering. If unsure, contact support@listmarinesolutions.com with the pontoon’s year, make and model, the rail measurement and a clear picture of the upper fence rail.

What’s Included

• 2 six-inch AT TOONLOK Platform sections
• 4 stainless-steel mounting bolts
• 4 washers
• 4 nylon-insert lock nuts
• 8 self-tapping screws for additional support
• 6 shims for varying pontoon fence dimensions — 3 for each platform section
• 1 matching-color pack of TOONLOK end caps
• Free standard U.S. shipping

Features

• Creates a standard 3-inch accessory track on pontoon fencing
• Two sections connect to create one continuous 12-inch track
• Sections may also be installed separately
• Compatible accessories can be mounted and repositioned
• Manufactured from outdoor-grade ASA material
• Strength tested
• Stainless-steel mounting hardware included
• Designed and manufactured in Michigan, USA
• Patent pending
• Available in black, white or gray

Installation and Shims

Test-fit both sections before installing or tightening any hardware. Confirm that each platform fits completely around the fence assembly, sits level and is not being forced, spread apart or distorted.

Each AT section may require no shims, one shim, two shims or three shims. Test each platform section individually. If a section has side-to-side clearance, insert one supplied shim between the platform and the pontoon fence assembly. Keep the shim flat and fully seated, then test the fit again. Add a second or third shim only if side-to-side movement remains.

Use only the number of shims required for each section to sit snugly against the fence with no side-to-side play before tightening the mounting nuts. Do not use the mounting nuts or excessive tightening to pull a loose-fitting platform tight.

Align the male and female interlocking ends to connect the two sections. The side connectors align the sections but do not replace the required mounting hardware. Secure each section independently using its included hardware.

Some pontoon models require drilling with a 1/4-inch drill bit, which is not included. Inspect both sides of the fence for wiring, cables and other obstructions before drilling. Do not overtighten the mounting hardware.

If either AT section remains loose after using all three shims assigned to that section, stop installation and contact support@listmarinesolutions.com.

Important

This package includes two AT Platform sections, their listed mounting hardware, six shims and one pack of end caps. Rod holders and other track-mounted accessories are sold separately.

TOONLOK platforms are not intended to be used as steps, seats, grab handles, tie-down points or lifting devices.

TOONLOK — Built to Expand.